Optimum Paint Prep & More SEMA 2015 Ask a Pro Blog Opti Coat Pro Back to Optimum Gloss Coat HyperSeal There and back again YouTube Optimum Gloss Coat (1 Year, 20k Miles) YouTube Opticoat Patented SIC technology 9H Scratch Resistant Hydrophobic. Optimum Gloss Coat 20cc Optimum Gloss Coat is the most advanced polymer system that forms a layer of clear coat over the automotive finishes. Optimum Gloss Coat provides better scratch and mar resistance, better UV resistance, better chemical etch resistance, and has better release properties than any other consumer product while providing unsurpassed gloss and slickness. Additionally, you can top Optimum Gloss Coat with any non abrasive wax or sealant of your choice to add additional gloss and slickenss. Optimum Gloss Coat can be used to protect the following surfaces: Painted Surfaces Wheels Plastic trim Bumpers Aluminum & Chrome surfaces Since Optimum Gloss Coat bonds to surfaces it is applied to, any paint imperfections must be removed withOptimum Polish II or Optimum Hyper Polish before application. Also all waxes and oils must be removed from the surfaces for proper bonding. Application : 1. Polish paint with Optimum Polish II or Optimum Hyper Polish to remove any defects. 2. Clean surface with 15% IPA solution to remove all polishing oils, waxes, and silicones. 3. Prime the applicator by making an X pattern across the pad. Only a few drops will be needed for each subsequent panel. 4. Wipe Optimum Gloss Coat onto a single panel at a time in a thin layer using two directions, in a circular or front to back direction. 5. Within 5 minutes, inspect the panel with adequate lighting looking for any thick areas that have not flashed away to clear. 6. Use foam applicator or paint safe microfiber to even out any areas where you see streaks. This step is key, as any spots not leveled will have to be polished if allowed to cure. Panels will feel a bit tacky and will be self leveling during cure time, so avoid any unnecessary touching, wiping, or contact to produce the best results. 7. Repeat steps 1 6 for each panel where application is desired. Not recommended for glass. Applicator included.